Análise numérica não linear de punção em lajes lisas com armadura de cisalhamento
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidade Federal de Juiz de Fora (UFJF)
DOI
Abstract
Reinforced concrete flat slabs are widely used in civil construction due to their architectural,
constructive and economic advantages. However, the slab-column connection is susceptible to
punching shear failure, a brittle failure mode relevant to structural safety. This work aimed to
develop and calibrate, using the Finite Element Method (FEM) and the Abaqus software, a threedimensional
numerical model capable of simulating the punching behavior of a reinforced concrete
flat slab with shear reinforcement and, based on this calibration, to carry out a parametric analysis
of variables that influence punching resistance. The experimental slab FS-08 was adopted as
reference, measuring 2500 mm × 2500 mm in plan, 180 mm thick, with an internal 300 mm square
column and closed stirrups as punching reinforcement. Concrete was represented by the Concrete
Damaged Plasticity (CDP) model and the reinforcement by truss elements. Calibration was based
on sensitivity analyses of the finite element type, mesh size, dilation angle, viscosity, fracture
energy and the constitutive models of concrete and steel, resulting in a model with C3D8R
elements, optimized mesh and a 35° dilation angle. The first load reduction occurred at
approximately 590 kN, close to the experimental load of 607.8 kN, with a failure mechanism
consistent with punching. The main limitation was the inability to reproduce the abrupt post-peak
load drop, since the model retained residual load capacity. Parametric analyses then assessed the
influence of concrete compressive strength (20 to 50 MPa), slab depth (160 to 270 mm), flexural
reinforcement ratio (bar diameters from 10 to 20 mm) and column geometry (square and circular).
It is concluded that the model adequately represented the global behavior of the slab-column
connection up to the failure region and can be used as a complementary tool to the experimental
investigation of flat slabs with punching reinforcement.
Description
Keywords
Punção , Modelagem numérica , Lajes lisas , Armadura de punção , Abaqus , MEF , Punching shear , Numerical modeling , Flat slabs , Shear reinforcement , Abaqus , MEF
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Creative Commons license
Except where otherwise noted, this item's license is described as Acesso Aberto

