Análise do comportamento estrutural de perfis de aço formados a frio com enrijecedores na alma aplicados como terças

Loading...
Thumbnail Image

Journal Title

Journal ISSN

Volume Title

Publisher

Universidade Federal de Juiz de Fora (UFJF)

DOI

Abstract

Cold-formed steel sections are widely used in roofing systems due to their high strength-toweight ratio and ease of manufacturing. However, because of their thin-walled elements, these members are more susceptible to instability phenomena, making the proper verification of their load-carrying capacity and service performance essential. This study presents the structural analysis of steel purlins from an actual roof structure, emphasizing the influence of intermediate web stiffeners on the structural behavior of the sections. Initially, the load combinations for the Serviceability Limit State (SLS) and Ultimate Limit State (ULS) were established, and the vertical displacements and bending moments were obtained using the FTOOL software. Subsequently, the sections were designed using the Direct Strength Method (DSM), according to ABNT NBR 14762:2010, with the aid of the CUFSM software to determine the elastic critical stresses and the resistant moments associated with global, local, and distortional buckling modes. A comparative analysis was then carried out among different cold-formed steel sections, considering both structural performance and steel consumption. The results showed that intermediate web stiffeners significantly increase the resistance to local buckling, allowing the use of thinner and lighter sections. It was also observed that sections with lapped connections over the supports provide greater structural efficiency, enabling the adoption of members with lower linear weight. Among the analyzed sections, the ZAE 280 section presented the lowest total steel consumption under the conditions evaluated, although the difference compared with the Z90 and stiffened U sections was relatively small due to the additional length required by the lap connections. It is concluded that the selection of the most appropriate section should consider not only strength and stability but also serviceability performance, constructability, and economic feasibility.

Description

Citation

Endorsement

Review

Supplemented By

Referenced By

Creative Commons license

Except where otherwise noted, this item's license is described as Acesso Aberto