Avaliação da resistividade elétrica e liberação de finos da escória de aciaria como lastro ferroviário
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidade Federal de Juiz de Fora (UFJF)
Abstract
The steel industry plays a fundamental role in the global economy; however, its
operation results in the significant generation of waste. At the same time, railway
transportation stands out for its high freight efficiency, although it requires substantial
consumption of natural resources for its infrastructure. In this context, a sustainable
strategy is the reuse of steelmaking waste as aggregate for railway ballast. Therefore,
this study aims to evaluate the technical feasibility of using treated steel slag as railway
ballast aggregate (steel slag ballast), with particular emphasis on fines generation and
electrical resistivity, the latter still scarcely explored in the literature. To this end, tests
of apparent specific gravity, apparent porosity, water absorption, Treton impact
toughness index, Los Angeles abrasion, electrical resistivity under different moisture
and fines contents, expansion assessment using the adapted PTM method, and the
correlation between fines content and abrasion cycles were conducted. The results
indicated an apparent specific gravity of 3,122 kg/m³, water absorption of 2.0%, and
apparent porosity of 5.5% (above normative limits). The Treton toughness index
obtained for the slag was 9.6%, and the Los Angeles abrasion value was 20.3%, both
in accordance with the literature and superior to natural aggregate (gneiss), which
presented 21.8% (Treton) and 21.6% (Los Angeles abrasion), indicating better
mechanical performance of the slag. Regarding electrical resistivity, slag exhibited
adequate values under dry conditions (2,580,000 Ω·m, compared to 3,900,000 Ω·m
for natural aggregate). However, with increasing moisture, resistivity decreased,
reaching values close to or below 60 Ω·m, while natural aggregate maintained 528
Ω·m at 16% moisture. The addition of fines and iron ore contamination was also
detrimental, with slag reaching as low as 27.9 Ω·m. Therefore, steel slag ballast is not
recommended for railway tracks operating with track circuit detection systems, but it is
suitable for sections that employ axle counter detection systems. These findings
support the feasibility of using steel slag as ballast, with restrictions in systems that
rely on electrical track circuits.
Description
Keywords
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Creative Commons license
Except where otherwise noted, this item's license is described as Acesso Aberto

