Comparação de geometrias de hélices para geração de energia eólica: experimento de bancada e simulação

Loading...
Thumbnail Image

Journal Title

Journal ISSN

Volume Title

Publisher

Universidade Federal de Juiz de Fora (UFJF)

DOI

Abstract

The expansion of the sustainable energy sector demands the development of accessible and efficient technologies for microgeneration. This work presents a comparative performance analysis between three-bladed and four-bladed wind propellers, based on the E205 aerodynamic profile, using a hybrid methodology that integrates computational simulation and physical experimentation. Simulations were performed using OpenFOAM v9 software, employing the Finite Volume Method (FVM), the RANS k − ε turbulence model, and the Arbitrary Mesh Interface (AMI) technique to reproduce rotor behavior in a virtual wind tunnel. Experimentally, PLA prototypes were manufactured via 3D printing and tested on an instrumented bench, where angular velocity was measured by a non-intrusive computer vision system. Results showed that the four-bladed geometry exhibited superior performance, achieving a higher steady-state rotation (25.52 rad/s versus 23.64 rad/s) and a higher power coefficient (Cp) under the applied test conditions. The comparison between models revealed an expected quantitative discrepancy between the simulated gross mechanical power (≈ 0.4 W) and the measured useful electrical power (≈ 0.003 W), evidencing that electromechanical conversion losses are the limiting factor in microturbines, rather than the aerodynamic design. It is concluded that the proposed methodology successfully confirms that the four-bladed configuration is more efficient than the three-bladed one for the conducted experiment.

Description

Citation

Endorsement

Review

Supplemented By

Referenced By

Creative Commons license

Except where otherwise noted, this item's license is described as Acesso Aberto