Influência de cinco diferentes protocolos de polimento na superfície da zircônia monolítica multicamadas avaliando suas características ópticas - translucidez, contraste e opalescência
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidade Federal de Juiz de Fora - Campus Avançado de Governador Valadares
DOI
Abstract
Polishing protocols aim to create a smooth, shiny surface with optical properties similar
to natural enamel. The objective of this work was to analyze the influence of five
different polishing protocols on the translucency, contrast and opalescence of
multilayer zirconia. Two different brands of zirconia were analyzed: Amanngirrbach
Zolid FX Multilayer and GoldF ML Multilayer, divided into five groups with ten samples
in each group (n=10), identified as “Group DA” (EVE Diacera - wheel with diamond
particles), “PA Group” Diamond Paste Polishing Paste with Aluminum Oxide), “PD
Group” (Diamond Excel Polishing Paste with diamond grain), “EX Group” (Exa-Cerapol
– KIT with three steps) and “GL Group ( Glaze Paste Insync)”. Each group was
analyzed using an EasyShade Advance 4.0 spectrophotometer before and after the
polishing protocol and the parameters of translucency (TP), contrast (CR) and
opalescence (OP) were evaluated. Data were analyzed by ANOVA and Kruskal-Wallis
and statistical significance was set at p<0.05. The values obtained for TP varied
between 0.68-2.32 for the Amanngirrbach samples, being more significant and
between 0.68-5.14 for the GoldF group samples. For CR they assumed a variance of
0.98-1.00 for both groups. For OP they varied between 0.25-2.24 for Amanngirrbach
and between 0.45-2.27 for the GoldF group. The values measured for the differences
between the After-Before means of the parameters for Amanngirrbach comparing the
groups and the sample thirds reveal that TP differences were identified in the middle
and incisal thirds, where the PD and EX polishing protocols differed between the thirds
and middle and incisal. For CR, for the most part, they were not significant (p>0.05),
differing only between the DA and PD groups, for the incisal third and for OP they
showed differences in the cervical third between the PA and GL groups and in the
incisal third , between the PD and EX groups. The GoldF values comparing the groups
and sample thirds reveal that PT differences were identified in the cervical, middle and
incisal thirds between the GL protocol and the others. For CR, in the middle and incisal
thirds, there was a difference between the GL protocol and the others and in the
cervical third, there were differences between DA, EX and GL. For OP, in the middle
and incisal thirds, no differences were observed between the protocols and in the
cervical third, the PA protocol differed from DA and EX. It is concluded that the
multilayer zirconia from the different manufacturers tested showed different
translucency and opalescence characteristics, which may suffer different influences according to the polishing protocol used. There is a prevalence of increased
translucency after the different polishing protocols applied. Contrast behaved
consistently in all groups analyzed, regardless of the polishing protocol used.
Opalescence in the middle thirds for Amanngirrbach and middle and incisal thirds for
GoldF did not differ regardless of the polishing protocols used.
Description
Keywords
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Creative Commons license
Except where otherwise noted, this item's license is described as Acesso Aberto

