Impressão 3D na área farmacêutica: novo método de incorporação de fármacos por modelagem por deposição fundida e a avaliação da percepção de mulheres e ginecologistas em relação a anéis vaginais impressos por 3D
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidade Federal de Juiz de Fora (UFJF)
Abstract
The application of three-dimensional printing (3D) in the pharmaceutical field
has aroused interest in the scientific community and the industry. In this context,
fused deposition modeling (FDM), which is based on the extrusion of a thermoplastic
filament, stands out. For the incorporation of the drug in the filament, there are the
methods of impregnation and hot melt extrusion, but they have limitations Therefore,
the objective of the first chapter was to develop a new method for the incorporation of
model drugs by FDM. For this, the following steps were carried out: 1) development
of a manual method of incorporation using FDM to produce plain tablets that were a
scaffold to support the application of a minoxidil solution; 2) automating the method
by coupling FDM and inkjet printing, in addition to evaluating the influence of ethanol
concentration on the dissolution of minoxidil tablets; 3) evaluate the method to
produce personalized rosuvastatin tablets, through the investigation of different
polymeric inks. The results obtained generated three scientific articles, where we
found that: 1) the manual method was effective to produce minoxidil tablets and the
drug was released in 5 minutes; 2) the automation of the method provided precision
and reproducibility, controlling drug deposition; moreover, the miscibility of the
solvent with the polymer influenced the site of drug deposition and release profile; 3)
the new method produced rosuvastatin tablets with personalized dose and release
profile. In the second chapter, 3D printing was used in the w field,
aiming to investigate the perceptions of women and gynecologists regarding 3Dprinted
vaginal rings with personalized shapes. The devices were produced in four
different geometries by FDM for a cross-sectional and quantitative survey with 155
participants. The majority of women stated that they would feel comfortable using
some of the 3D-printed vaginal ring geometries and demonstrated good acceptability
for the traditional and two innovative geometries. However, women presented
multiple preferences, with no single preferred geometry. In addition, their background
was associated with the acceptance of geometries. Most gynecologists would
prescribe the traditional and one innovative geometry, which were well evaluated in
technical parameters. Their preference was also clear for these two geometries.
Overall, although there was a difference in the perception between women and
gynecologists, they had a positive opinion about the 3D-printed VRs, which indicates
the feasibility of 3D printing to produce acceptable VRs. Finally, the personalized VRs
could lead to an increase in therapeutic adherence, by meeting women's varied
preferences.
Description
Keywords
Impressão 3D , Manufatura aditiva , Medicamentos , Modelagem por deposição fundida , Impressão por jato de tinta , Personalização , Anel vaginal , Saúde da mulher , 3D printing , Aditive manufacturing , Medicines , Fused deposition modeling inkjet printing , Personalization , Vaginal ring , Women´s health
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Creative Commons license
Except where otherwise noted, this item's license is described as Acesso Aberto

