Análise microscópica da superfície de moldes obtidos com diferentes hidrocolóides irreversíveis submetidos à três técnicas de manipulação
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidade Federal de Juiz de Fora - Campus Avançado de Governador Valadares
DOI
Abstract
One of the causes of increased imprecision of moldings is the formation of bubbles
on their surfaces during impression taking, different handling methods and
compositions of the impression material may influence this unwanted
phenomenon. Objective - To analyze defects (bubbles) in molds produced from
three distinct manipulation techniques using two different alginate formulations.
Methods - For the test the selected alginate formulations were Hydrogum® and
HydrogunFive®. The techniques used were the conventional handling of Skinner &
Pomes, the handling by Shelley and Alsup plastic bag technique and the vacuum
handling technique. Samples were obtained in triplicate. The upper arch of a
mobile dental mannequin was used as a matrix. The number of bubbles was
counted using a 16-fold magnifying MC-M12ERGO® microscope, each bubble
was counted within the previously delimited area in the anterior palate regardless
of its size. Data were subjected to statistical analysis where a test was performed
to verify normal distribution of results (Komolgorov-Smirnoff test - n> 50). After
confirming the normal distribution of data, the analysis of variance (ANOVA),
multiple comparisons, Student's t-test and post-Tukey tests were applied, all with a
significance level of 5% using the SPSS version 19.0 software. Results - There
are differences between the averages of bubbles formed by the Conventional
Skinner & Pomes, Shelley and Alsup plastic bag and vacuum techniques. The
vacuum technique obtained fewer bubbles and irregularities on its surface,
however these differences are not statistically significant (p = 0.062). The number
of bubbles formed with Hydrogum® alginate is smaller than the number of bubbles
formed by Hydrogum Five® by the three spatulation techniques, but this difference
is
not
statistically
significant
(p=0.491).
Conclusions
-
The vacuum spatulation technique obtained smaller number of bubbles and
irregularities in its surface being the most precise technique. The technique that
most formed bubbles on the surface of the molds was the conventional technique
of Skinner and Pomes. Among the six groups studied, the one that obtained the
best results was the group that used Hydrogum® alginate and the vacuum
manipulation technique (HT3), producing fewer surface bubbles.
Description
Keywords
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Creative Commons license
Except where otherwise noted, this item's license is described as Acesso Embargado

