Desenvolvimento de método por voltametria de redissolução anódica empregando a eletrodissolução para a determinação de cádmio e chumbo em amostras de eletrodo revestido modelo E6013
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidade Federal de Juiz de Fora (UFJF)
DOI
Abstract
The determination of cadmium (Cd+2) and lead (Pb+2) present in E6013 electrode samples was performed using anodic redissolution square wave voltammetry (VOQRA) and a bismuth film electrode (BiFE). As a comparison, mass spectrometry with inductively coupled plasma (ICP-MS) was used. Electrodissolution was used in comparison with acid digestion in the heating plate in the sample preparation step for the determinations of Cd+2 and Pb+2 in the metal parts of the E6013 electrode samples. For electrodissolution, the use of syringes as low-cost electrolytic vats has been proposed, using as an electrolyte a combination of solutions of nitric acid (HNO3) 1.0 mol L-1 and hydrochloric acid (HC) 0.1 mol L-1 . A charge study showed that 900 Coulombs were sufficient to obtain a good electrodissolved mass in a short period of time. The stage of preparing samples by electrodissolution showed recovery rates in the range of 92.1 to 103.6% for the analytes, showing better in relation to the acid digestion in the heating plate. The optimization of VOQRA conditions resulted in a gain of sensitivity in relation to the proposed initial conditions, obtaining in this technique instrumental detection limits (LD) equal to 0.65 µg L1 for Cd+2 and 1.28 µg L-1 for Pb+2 . The method was applied to four samples of coated electrode model E6013, and in all cases the Cd+2 concentration was below the LD and the Pb+2 concentrations obtained by VOQRA were in agreement with 95% confidence with those obtained by ICP -MS.
Description
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Creative Commons license
Except where otherwise noted, this item's license is described as Acesso Aberto

