Efeito da orientação de impressão nas propriedades físicas de resinas impressas 3D utilizadas para base de próteses totais
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidade Federal de Juiz de Fora (UFJF)
Abstract
The use of 3D printing in the fabrication of complete dentures is relevant as it
minimizes laboratory steps, thereby reducing variables inherent to the conventional process
and associated fabrication errors. This study aimed to evaluate the physical properties of
four brands of 3D-printed denture base resins (Cosmos Denture [CD], SmartPrint [SP],
PriZma 3D Bio Denture [PZB], PrintaX BB Base [PXBB]) at different printing orientation
angles (0°, 45°, and 90°), compared to a control group (CG) using heat-polymerized resins.
A total of 130 circular specimens were fabricated (n=10), including 120 printed and 10
conventional, with dimensions of 10 mm in diameter and 3 mm in thickness. Color analysis
was performed using a benchtop spectrophotometer. Surface roughness was measured
with a profilometer to obtain Ra values. Hydrophilicity was assessed using the sessile drop
method with a goniometer. Additionally, sorption and solubility analyses were conducted
using a desiccator and drying oven. All samples underwent thermocycling for 10,000 cycles
to evaluate the influence of thermal aging on the materials. Data were subjected to normality
testing. For color, hydrophilicity, and sorption parameters, parametric analysis of variance
(ANOVA) followed by Tukey's post hoc test was applied. Non-parametric data for roughness
and solubility were analyzed using the Kruskal–Wallis test. The different resins did not
significantly affect surface roughness (P=0.576) or hydrophilicity (P=0.217); however,
significant differences were found for color (P<0.001), sorption (P<0.001), and solubility
(P=0.003). GC and PXBB resins showed greater color change compared to CD, SP, and
PZB resins (P<0.001), with no significant differences among the latter (P=0.141). CD resins
showed lower sorption and solubility values compared to GC, while GC presented results
similar to the other printed resins. Printing orientation did not influence color change
(P=0.356), surface roughness (P=0.565), hydrophilicity (P=0.567), sorption (P=0.152), or
solubility (P=0.820). Thermocycling significantly increased surface roughness and
decreased hydrophilicity of the 3D-printed resins (P<0.001). Therefore, it can be concluded
that 3D-printed resins exhibit physical properties comparable to conventional heatpolymerized resins and are not affected by printing orientation. Thermocycling can influence
surface roughness and hydrophilicity of the evaluated resins.
Description
Keywords
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Creative Commons license
Except where otherwise noted, this item's license is described as Acesso Aberto

