Nanoestruturas de carbono: sínteses, caracterizações e aplicações em dispositivos optoeletrônicos
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Universidade Federal de Juiz de Fora (UFJF)
DOI
Abstract
In this work, graphene and amorphous carbon pure (𝑎-C) and doped with nitroge n
(𝑎-CNx) thin films were grown, characterized and employed in the fabrication of
optoelectronic devices.
Thin Films of 𝑎-C and 𝑎-CNx were employed as electroluminescent layer in light-
emitting devices. These films were grown employing the technique of RF Magnetron
Sputtering in three series of depositions where were optimized the N 2 gas flow, the power
of deposition and the films thickness. After the growth, this films were structura lly,
compositionally and optically characterized employed the technical of X-ray diffract io n,
X-ray photoelectron (XPS) and optical absorption spectroscopy in the UV-Vis region.
The results obtained with these characterizations were related with the efficiency and
luminescence of the light-emitting devices fabricated from these films that, for this
purpose, were grown on ITO substrates, employed as anode, and below a film of
aluminum of 120 nm, employed as cathode. The best device exhibited an
electroluminescence spectrum that covers practically all the visible region, with a
maximum luminescence of 206 cd/m2 at 9.86 V and current efficiency of 1.31x10-2 cd/A
at 15.62x10-4 mA/cm2. These values are about three orders of magnitude greater than
other similar devices found in literature.
Graphene films were grown by CVD technical and employed as anode in the
fabrication of OLEDs with the following architecture: Graphene/CuPc/𝛽-NPB/Alq3/ A l.
The graphene films were electrically, optically and structurally characterized employed
the technical of Hall effect, UV-Vis optical absorption spectroscopy and Raman
spectroscopy, respectively. The graphene films exhibits sheet resistance of 500 Ω/square ,
high optical transmittance in the visible region of about 90% in 550 nm and high degree
of crystallinity, besides great uniformity in large areas. The graphene OLED (G-OLED)
turn on with an applied voltage of 2.75 V much earlier than reference OLED fabricated
employed commercial ITO as anode, (I-OLED), that turn on with a voltage of 3.80 V.
The I-OLED exhibited the maximum of current efficiency of 0.95 cd/A in a luminesce nce
of 1400 cd/m2, much smaller than exhibited by G-OLED, that for the same luminesce nce
exhibited a current efficie ncy of 9.67 cd/A, reaching a maximum of 19.26 cd/A in 6352
cd/m2. The power efficiency of G-OLED is one order of magnitude greater than I-OLEDof 4.9x10-2 lm/W in 0.27 cd/m2. Furthermore, the maximum of electroluminesce nce
exhibited by G-OLED of 6351 cd/m2 in 11.20 V is higher than I-OLED of 5863 cd/m2 in
10.75 V
Description
Keywords
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Creative Commons license
Except where otherwise noted, this item's license is described as Acesso Aberto

